Work continues on the port side. The third layer of the hull is coming along nicely.
 |
| Thirteen strips on the third layer. I managed to put in 8 strips in this weekend over one of the most difficult sections of the hull. |
 |
| Another view of the work performed this weekend. A close look shows how I marked the cut line at the keel. I mark it as I go. This makes it much easier to cut later. An old yogurt container (shown center) makes the perfect container which holds just enough epoxy for a single strip. I get about 3 or four uses before the container cracks or becomes unusable. The residual epoxy left behind pops out clean once cured. It also comes with a lid so I can premix (without hardner) and store it when necessary. |
